Metal Set Epoxy
£7.49 inc. VAT
FAST SETTING LIQUID METAL BONDER
Bondloc’s Metal Set Epoxy is a steel-filled epoxy for general maintenance and repairs. For filling, rebuilding and bonding metal surfaces. Bonds most metals and concrete. For repairs, worn or fatigues metals, patch castings, making of jigs and fixtures rebuilds pump and valve bodies, restores bearing journals and races. Applies easily, needs no special tools. Machinable. Resistant to most chemicals. Working time is 15 minutes at 24°C functional (75%) cure is achieved in 6 hours.
Sku : Auto13
- Colour Metallic
- Bonds Metals
- Bonds Concrete
- Rebuilds Metal
- Repairs Worn Metal
- 15 Mins Handling
- Easy Application
- No Need For Tools
- Machinable
- Chemical Resistant
- Liquid Resistant
PART A: Resin
Warning : May cause an allergic skin reaction. Wear protective gloves / protective clothing / eye protection / face protection.
If On Skin : Wash with plenty of water. If skin irritation or rash occurs, seek medical advice / attention. Collect spillage. Dispose of contents / container in accordance with national regulations.
Contains : Bisphenol-A (epichlorhydrin), Formaldehyde, oligomeric reaction products with 1-chloro-2,3-epoxy-propane and phenol.
PART B : Hardener
Danger : Causes severe skin burns and eye damage. May cause an allergic skin reaction. Do not breathe vapour / spray. Wear protective gloves / protective clothing / eye protection / face protection.
If Swallowed : Rinse mouth. Do NOT induce vomiting.
If On Skin (or Hair) : Take off immediately all contaminated clothing. Rinse skin with water or shower. If skin irritation or rash occurs, seek medical advice / attention.
Contains : Triethylene Glycol Dimercaptan, N(3-dimethylaminopropyl)-1,3-propylenediamine.
Proper surface preparation is essential to the success of any epoxy application. In all cases, the surface should be clean, dry, free from oil.
- Remove all oils, dirt and grease by means of a strong cleaner/degreaser.
- Roughen the surface.
- All abrasive preparation should be followed by another clean.
- Ideal application temperature is 13°C – 32°C. Under cold conditions, heating the repair area to 38°C – 43°C is recommended.
- Mix equal quantities of the two parts, a static mixing nozzle is supplied, the 2 parts will be mixed correctly upon dispensing.
- Spread mixed material over the repair and work firmly into the substrate to ensure maximum surface contact. To bridge large gaps or holes, use fibreglass tape, expanded metal or mechanical fasteners.
- Allow material to cure for at least 4 hours before machining.
